A-3600-BKR

This is a red steering wheel that fits the hub for the 2 tooth steering gear.

Now you can take advantage of the 2-tooth steering gear and still install a reddish-brown steering wheel in the original design that belongs in your early Model-A.

When Ford began using the two-tooth sector in 1929, this was the steering wheel that was installed on these steering boxes

Diameter 44.5cm

Hole diameter below 20.5mm

Hole diameter at top 17.8mm

Hub length 30mm

A NOTICE:

All USA steering wheels are unmachined and require trimming of the cast seam.

INSTRUCTIONS FOR REFINISHING STEERING WHEELS

For those of you who think that these steering wheels have a high gloss finish like a bowling ball, you are unfortunately wrong.

It looks like Ford used a very coarse file for deburring.

To keep costs as low as possible, here are some helpful tips for a fine finish on your steering wheel.

1. Use an exacto knife or a utility knife to first remove the excess burr from the

Parting line. (where the mold halves come together). and not to cut too deeply into the steering wheel.

2. Take a fine file and file the mold line until it blends with the wheel.

3. Now the work begins! Take some 600 grit sandpaper (wet) and

and wet sand the areas you just filed. Wet sand these areas until the

Form line disappears. Allow the grinding wheel to harden and dry.

4. Now the areas you wet sanded will look a little duller

than the rest of the steering wheel. Rub these dull areas by hand with a fine brush

buffing compound. The more you polish, the better your end result will be.